D-Link DWL-900AP

Q.Why doesn't the SNMP work unless its plugged in to the usb ?
A. It seams the firmware in the Dlink 900ap has snmp broken (1.4h2),
      the best fix is to download a new firmware from www.linksys.com
      (Wap11 version 1.x firmware and snmp tools)
      plug in the 900ap in to the usb port and run the flash upgrade,
      the linksys flash tool is better then dlinks old one where the linksys one has a status of how much its
       uploaded to the unit, and dlinks just shows a happy face,
      After firmware is installed run the snmp tool and off it should work,,

Q. what kinda antenna socket does this beast have ?
A. RP-SMA,,(reverse polarity SMA) (not to be confused with RT-SMA)
     

Q.  I am a tight ass, Can i mod this unit and not spend $30 on a pigtail ?
A. Yes, you can buy a normal SMA from places like jaycar for about $4
     the only diff from a normal SMA and a RP-SMA is the centre pin.. with a lil spare time you shouldn't have problems making one,

Q. But i am EVEN tighter assed,,, can i just bypass the whole RP-SMA
A. Yes, you can directly solder on to the board, (for the Skilled with small parts)
The Unit with Top off. DAMN Small
YES Dual antenna support.




Q. Can i run the Dodgy Wap 11 100mw hack on 900ap ?
A. YES Its based on the same chip set as the Wap11 and NetGear's ap's,
      How ever i don't think i would recommend it


Q. What's the Tech spec's ?
A.
Technical Specifications
  Standards
  • IEEE 802.11b (Wi-Fi Certified)
  • IEEE 802.3 10Base-T Ethernet
  Ports
  • (1) RJ-45, 10Base-T Ethernet port
  • (1) USB 1.1, Type B
  Network Protocols
  • TCP/IP
  • IPX/SPX
  • NetBEUI
  • ARP
  • SNMP
  • DHCP
  • NDIS3
  • NDIS4
  Data Security       64-bit, 128-bit WEP (Wired Equivalent Privacy)
      Encryption
  Data Rate and Modulation
  • 11Mbps - CCK
  • 5.5Mbps - CCK
  • 2Mbps - DQPSK
  • 1Mbps - DBSK
  Power Input
  • DC 5V, 1A
  • Use External Power Supply
  Antenna       One External 2.5dB gain antenna w/ reverse SMA
      connector
  Transmit Power
  • +12.5dBm typical
  • Up to 900ft outdoors or 300ft indoors
  Reception Sensitivity
  • Nominal Temp Range
  • - 1Mbps 10-5 BER @ -89 dBm, Minimum
  • - 5.5Mbps 10-5 BER @ -83 dBm, Minimum
  • -11Mbps 10-5 BER @ -79 dBm, Minimum
  Frequency Range
  • 2.4 - 2.497 GHz ISM band
  • 11 Channels
  Modulation       Direct Sequence Spread Spectrum (DSSS)
  Operating Modes
  • Access Point
  • Wireless Bridge
    • Point to Point
    • Point to Multipoint
  • Client AP
  Roaming       Among Access Points on the same subnet
  Management
  • SNMP Manager to manage wireless LAN, network connection and client access control
  • USB Configuration
  • TFTP Client for firmware upgrade
  • Set IP Session (ARP/ping)
  • DCHP client
  Diagnostic LEDs
  • Power (Green): Power Indicator
  • Link (Green): Ethernet Link Indicator
  • WLAN (Green): Wireless Link Indicator
  Temperature
  • Operating Temperature: -0°C to 55°C
  • Storing Temperature: -20°C to 60°C
  Humidity       Max. 95%, non-condensing
  Emissions
  • FCC
  • CE
  Safety
  • UL
  • TUV
  Warranty       One-Year Warranty